When mounting this unit outside, apply silicone to the area where the wires. The bi-color LED provided with the SE keypad illuminates red when the Lock-Release relay is de-energized and green when the relay is de-energized. The following defaults have been factory. To avoid ESD (Electro-Static Discharge) interfering with the operation of the keypad, ground the housing to earth ground. SPECIFICATIONS Case Dimensions: R Keypad: 3.75W x 5. Prox. The Door-Gard Command and Control Series keypads are designed for easy installation in a minimum amount of time. On SE keypad, holes have also been spotted inside the front housing for additional LEDs (LEDs not included). Guía de programacíon para el usuario 620-100440D This equipment is designed to be installed and serviced by security and lock industry professionals. This manual applies to these models: 212e, 212eM, 242e, and 242eM. Intrusion Detection and Access Control Accessories Sub-Catalog (.pdf) 4 (1) e/eM Style Standalone Keypad Installation/ Programming.427 TURNPIKE STREET 78 (FAX) WEB ADDRESS: The diagram above shows how to connect two keypads to control a single door. If you CANTON, MA 02021 USA 80, 78, Security Screws (2) INTERNATIONAL ELECTRONICS, INC. Stand Alone Access Control Sub-Catalog (.pdf) negative terminal of the keypad to earth ground.Secured Series PC Based Systems Sub-Catalog (.pdf).eMerge Embedded Software Systems Sub-Catalog (.pdf).Click here for eMerge Support Documentation CD.By default (auto-entry is off), all codes must be followed by the key. The master code allows access to programming mode and activates the main relay. 1 The master code is always stored in user location 1. New Installations Only Programming Software DoorGard Command and Control keypads are factory programmed with a master code of 1234. Linear currently supports the changes in the Daylight Saving Time schedule as part of the Energy Policy Act of 2005 in AccessBase version 1.54 and AccessBase 2000 version 2.6 and later. After the uninstallation has been successfully completed, run the V1.54 installation package again to install V1.54. ![]() During the uninstallation process, there will be window pop-ups that will ask whether to delete files that are no longer used by other applications. When installing V1.54 over V1.52, V1.52 will be uninstalled first. 2000e & 2000eM Keypad Installation & Programming Instructions Note: This product is designed to be installed and serviced by security and lock industry professionals. ![]() For new installations it is required that AccessBase V1.52 be installed first before installing V1.54. Questions can also be submitted through our website at End User: Please contact your service company. AccessBase for Access Control Systems – AM/II, AE-1, and AE-2ĪccessBase V1.54 is a version upgrade for the V1.52 release. Service Company: To contact IEI’s Technical Support department, call 1- 80, Monday through Friday.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |